send link to app

Call List Pro


4.0 ( 9440 ratings )
유틸리티 생산성
개발자: Kai Bruchmann
2.99 USD

General:
- Connect per WLAN, GPRS, EDGE or UMTS.
- All contents can only be showed online.
- The call list can only be requested per remote query, not over the internal net http://fritz.box !
- Fritzboxes from 7170 and up will be supported
- For a continuous deployment and proper function of the service site can not be guaranteed.
- New: DTMF dial with fixed-line phone
- New: Callthrough function

Use:
- Start the program
- call up the settings
- Enter the data of your Fritzbox
- The buttonTest only checks if your Fritzbox can be pinged
- Press Save and exit the settings
- Press the button Calls
- If all data is correct and the Fritzbox is set correct, then you should see the call list

Configuration of the Fritzbox:
- Establish a free DYNDNS-Account (e.g. at www.dyndns.org)
- Enter the data in the Fritzbox: Startpage* > Dynamic DNS
- Activate remote servicing: Startpage* > remote servicing
- Assign a password of the Fritzbox for internet access (not realy necessary)
- Enter all values to the settings of the iPhone program
* Startpage: http://fritz.box (Desktop PC: run a Browser)

Functions:
- Per click on a phone number you can make the call
- The program replaces 0 by e.g. +49
- Symbol AB: It is used a complex calculation, but it can happen that this symbol is showed and there is no message left.

DTMF Tone dial (from Version 1.2):
- Click longer on the time at the right in a row (not on the number)
- The row will be marked
- Presse "copy"
- The number occurs now above in the text field
- You can edit the number or enter a new one
- Use another fixed-line phone and pick it up so that you can hear the free line signal
- The fixed-line phone must support DTMF dialing
- Hold the microphone near the speaker of the iPhone
- Press the button "DTMF Dial"
- The number is now dialed with tone dial.
- After a short time you will be connected with the subscriber

Callthrough (from Version 1.4)
- Usefull if youhave a pricy fixed phone contract and want to phone cost-effective
- Enter in the iPhone App the Fritzbox-phone number and PIN
- Activate in the Fritzbox the Callthrough function
- Clicklonger on the time at the right in a row (not on the number)
- The row will be marked
- Press "copy"
- Now the complete number occurs above
- Click on this number and use now the function.

Settings for Callthrough in the Fritzbox:
- Call http://fritz.box in the Browser
- Settings > Extended settings > Telephony > Call forwarding > Callthrough

Hint:
It works with old and new (SessionID) Firmware, e.g.:
7170: 29.04.70 or higher
7270: 54/74.04.70 or higher
7390: 5.28 or 5.50 or higher
6390: 5.28 or higher
and future versions